Your Monton will arrive in a large cardboard envelop.  Please follow these steps to ensure your Monton is not damaged and installed correctly.

Installation

Step 1 – Preparation
•    Make sure your computer monitor is clear of tape, pictures, sticky note, etc.
•    Tear the cardboard tab to open the envelop.
•    Very carefully reach in and grab the thin sheet and slowly pull.  Do not grab the actual Monton.
•    Your Monton will be centered on the thin sheet, you can gentle lift this off (it will be secured by a light glue dot)

Step 2 – Secure Top
•    You will notice on the back of your Monton three (3) securing strips.  Peel the back off the top.
•    Carefully align your Monton so that the bottom is 1/8 inch above your screen and level.
•    Firmly press your Monton in place, careful not to leave fingerprints.

Step 3 – Secure Sides
•    Lift the left side and carefully remove the back of the tape.  Pull down and firmly place the side down.
•    Repeat for Right side.

Removal
1)    Carefully pull the bottom of the Monton upwards in an even fashion to prohibit tearing.  
2)    Carefully pull the top section off evenly.
3)    If any residue remains you can pull the tab on the tape strip.  This will slowly stretch and remove the tab with no residue.

Montons are not designed to be compatible with all monitors, they are designed to fit specific monitor dimensions, we do not warranty that the Monton can be used on other monitors or removed and re-installed.